Heart Entrance 2003

This 12' wide by 9' tall balloon wall section is made with three RMS-2 Builders filled with 11" balloons inflated to 8" in diameter. The heart shape is simply cut out with scissors.

Two base plates with vertical poles may be used to support the wall. Or, the wall could be supported from above with lines to the ceiling.

Some of the openings are divided in half and filled with smaller balloons to smooth out the curves in the heart shape.

This design leaves a 3.5' walk way at the floor level and considerably more space for elbow room. This is not only an effective entrance, but would make a nice frame for photos of couples and small groups.

Download the pattern for this heart entrance from http://www.rouseinternational.com/downloads/pdf/WalkThruHeart.W.pdf

Download honeycomb graph paper to lay out your own designs from http://www.rouseinternational.com/downloads/pdf/bldr.2.graph.pdf

Download a general instruction sheet for using the RMS Builders from http://www.rouseinternational.com/downloads/pdf/RMS-2BannerBuilderDir6.6.00.pdf

View purchasing information on RMS Builders at http://www.rouseinternational.com/Catalogs - Gen. Cat. - HONEY PANELS