Walk-Thru Heart Wall

This 12' wide by 9' tall balloon wall section is made with three RMS-2 Builders filled with 11" balloons inflated to 8" in diameter. The heart shape is simply cut out with scissors.

Two base plates with vertical poles may be used to support the wall. Or, the wall could be supported by lines to the ceiling.

Some of the openings are divided in half and filled with smaller balloons to smooth out the curves in the heart shape. This design leaves a 3.5' walk way at the floor level and considerably more space for elbow room. This is not only an effective entrance, but would make a nice frame for photos of couples and small groups.

Related Design Galleries
Visit one or more of the galleries listed in the navigation bar at the top of the page.
OnLine Directions
Specific directions are not available for online viewing, but do visit RMS Basics and the Banner Tutorial for related information.
Directions In Print
Click above to downloadthe pattern for this wall. You may also download instructions for the RMS Builders used to make the wall. Then view and print with "Acrobat Reader". Available FREE if not already installed in your computer.
RMS Catalog
Visit the Rouse Custom Shop General Catalog for purchase info on the RMS Builder expandable frameworks used to make this design.
RMS Honeycomb Graph Paper
Download the Honeycomb Graph Paper for RMS Builders so you can plan your own variations of this design.
RouseAbout OnLine Magazine
Read about this and related designs in the "Valentines - 2003" issue of RouseAbout..
Search RouseInternational.com
Use our search engine to locate related material within RouseInternational.com.

Contact Rouse International at:   info@RouseInternational.com          Return to Top




Last Updated: 15-March-2003
WebMaster: graham@RouseInternational.com
copyright 2003 Rouse International