ROUSE CUSTOM SHOP - Your Source For Picture Perfect Graphics To Sell Your Next Big Job!  

This classic, three element balloon sculpture uses # 350 balloons stretched over 22" clear plastic tubes.  It has a special, patented seal mechanism that allows chemical lights to be added at the last minute to the inside of the balloons while the balloons remain inflated.

Related Design Galleries
Visit one or more of the galleries listed in the navigation bar at the top of the page. [Under Construction]
OnLine Directions
Not available
Directions In Print
Click above to download. Then view and print with "Acrobat Reader". Available FREE if not already installed in your computer.
Custom Catalog
Lite-SculpturesTM like Nite-LitesTM are not yet in the Custom Catalog, but they are available on special order from Rouse International.
Search RouseInternational.com
Use our search engine to locate related material within RouseInternational.com.
Activate the necklace size (21.5") chemical lights as late as possible before your event start time. Pick the centerpiece up off the table. Slide the chemical lights into the balloons through holes in the bottom of the bases. Place the centerpiece back on the table.

The chemical lights are usually effective for four to six hours. The effect is stonger with low room light.

It is possible to adapt this system to use battery powered "neon wire" lights instead of chemical lights.

This design was created by Graham Rouse of Air Apparent Special Events in Columbia, SC USA in the early 1990's.  You may contact Graham at graham@rouseinternational.com.

Contact Rouse International at:   info@RouseInternational.com          Return to Top



Last Updated: 9-January-2003
WebMaster: graham@RouseInternational.com
copyright 2003 Rouse International